Seite 26 von 33
OPERATION
You can set all functions directly on the unit or using the remote control. Depending on the
function set, the indicator lights on the control panel light up.
Point the remote control directly at the front of the unit, making sure that there are no
obstacles between the remote control and the unit.
SWITCH ON THE UNIT
1. Press the
- button to switch on the unit.
2. The
- indicator on the display lights up.
3. Press the
- button again to switch to standby mode.
4. In standby mode, the indicator
- lights up red.
NOTE
Never switch off the air purifier by unplugging it directly from the mains.
To switch off, always press the on/off button and wait a few minutes before disconnecting
the unit from the mains. This allows the unit to go through a cycle of checks to verify its
functionality.
SET FUNCTIONS
Set fan speeds
Use the
- button to set the speed level of the fan.
1. Press the
- button to change the fan speed.
2. You can choose between 3 different speed levels by pressing the
- button until the
desired level lights up.
3. For each speed level of the fan, a dot lights up on the display:
E.g.: 1 dot
= fan level
1
2 dots
= fan level
2
3 dots
= fan level
3
Ion function
Use the
- button on the remote control or the "ION" button on the unit to start the
function and
the respective indicator lights up.
The unit now starts to distribute ionised air into the room.
Press the button again to deactivate the function.
Swing function
Use
the
- button on the remote control
or the "
SWING
"
button on the unit to activate
the swing function of the unit -
the respective indicator lights up.
Press the button again to deactivate the function.
