19 November 2008
BD X-Monitor 2 #
1080500
26
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ship: #88 – 446 Harrison St, Sumas, WA 98295 Mail: PO Box 231, Sumas, WA 98295
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
9. Locate the oil filter housing. This
is easiest to find from under the
driver’s side of the engine. On
the oil filter housing, look for the
3/8” bushing that uses an 8mm
hex head for removal. This port
should be located towards the
front of the housing and should
be facing the driver’s side front
tire. Have a rag ready as you will
spill some oil. Make sure that the
vehicle has cooled off as the oil
can be very hot.
10. Using Teflon tape, install the
bushing into the port. Be careful not to over-tighten it.
11. Route the purple wire from the X2 wiring harness to the temperature sensor.
Remove the nut and washers from the sensor and install the purple wire.
12. Replace the washers and nut onto the temperature sensor. Make sure that the nut
is secure but do not over-tighten it.
13. Go over the wiring harness and secure it to the vehicle (out of harms way) using the
supplied wire ties. Keep all wires as far away from moving or hot parts of the engine
as possible.
14. Slide the green plug through the rubber grommet where you ran the lead wire. Pull
enough of the wire harness inside the cab so that the switch port connection (white
and black wires), the black wire with the ring terminal and the red wire with the fuse
tap are inside the cab.
15. Find the bolt located by the firewall and remove it. Place the bolt through the ring
terminal of the black wire and screw it back into its location.
16. Open the fuse box located on the inside of the truck on the driver’s side of the dash.
You will be required to open the driver’s side door to access the fuse compartment.
17. Re-install the fuse. Attach the red wire with the fuse tap to the fuse labeled “IGN”
18. Once everything is secure and installed, you will want to start your engine. The X2
comes pre-set for these 4 parameters. To make sure everything is installed
correctly, use these basic guidelines:
