19 November 2008
BD X-Monitor 2 #
1080500
12
BD Engine Brake Inc
A10 – 33733 King Rd, Abbotsford, BC, Canada V2S 7M9
Ship: #88 – 446 Harrison St, Sumas, WA 98295 Mail: PO Box 231, Sumas, WA 98295
Ph: 604.853.6096 Fax: 604.853.8749 Internet: www.bd-power.com
Dodge 2003-2006 5.9L
1. Find the lead wire. This is a 2-wire harness with an orange and black wire. The
larger connector needs to be connected to the thermocouple.
2. Route the lead wire across the engine bay to the driver’s side. Tie the lead wire out
of the way of any moving or hot parts to avoid damage to the wires.
3. On the driver’s side firewall there is a rubber plug. You can either pop the rubber
plug out or cut a slit in it to route the small connector and wire the cab.
4. Plug the small 2-wire plug into the corresponding plug on the cable harness.
5. Lay wiring harness #1 out on your engine. The green plug will go inside the cabin
using the same location you routed the lead wire through.
6. Locate the engine’s MAP sensor. This is on the driver’s side of the engine, next to
the valve cover. It has 4 wires coming from it.
