immerse any part of the system in water or in any
other liquids.
11. Do not attempt to repair or replace any part of this
equipment unless it is specifically recommended
in this manual. The cable of the device cannot be
replaced. The complete unit must be replaced if
there is any damage to the power cable. Never
remove the plug, but always leave the electrical
unit intact. An electrical unit with the plug removed
will no longer be covered by the guarantee. All
other services should be referred to a qualified
technician.
12. Plug the unit into a 220V AC outlet only, 50-60Hz,
if unsupervised, it may cause an electric shock.
13. Do not use the device if any of the components
are damaged.
When using your AS8.1 or AS8.2 model, basic safety
precautions should be observed, including the
following.
1. Use the unit only for its intended use. This product
can only be used according to the guidelines
described in these instructions for use.
2. To protect against a risk of electric shock, do not
immerse any part of the system in water or in any
other liquids.
3. This appliance is NOT a toy. Keep children away
from this device and from the cable.
4. This appliance is NOT to be used by children or
persons with reduced physical, sensory or mental
capabilities.
5. Children should be supervised at all times.
6. Never look directly at a burning ultra-violet light,
as this may permanently damage your eyes.
7. To reduce the risk of an electric shock or damage
to the unit, switch the off and unplug before
cleaning or performing any maintenance to the
unit.
8. Heed all warnings.
This device produces harmful radiation. Direct
contact could impair the eyes and skin.
1. No form of water or liquid should enter the unit.
Should this occur, immediately switch off the unit
and unplug it.
2. Do not place any heavy objects on the power cord
as this may cause a fire and/or an electric shock.
3. Make sure the power cord is plugged firmly into
the outlet. If the power is not plugged in correctly,
this may cause a fire.
4. Do not touch the plug with wet hands, as this may
cause serious injuries as well as never insert the
plug / pull the plug from the socket when you are
standing in water.
5. Do not block the air inlet of the unit, as this will
reduce the airflow and result in poor performance
and damage the unit.
6. Do not sit, stand or place heavy objects on the
unit, as this may result in injury and/or damage
to the unit.
7. Do not move the product while it is switched on
as this may cause a fire and/or an electric shock.
Always remove the plug from the socket before
carrying out any maintenance or repair work on
the unit.
8. Do not alter or modify the plug or cord of this unit
as it could cause a fire or an electric shock.
9. Use the proper power cable and outlet, do
not over-load the outlets with several cords
simultaneously. Always comply with the electricity
company’s regulations with regard to any
permanent connection to the mains. If there is
any doubt regarding the connection, consult a
recognized electrician or the electricity company.
Always work with an earth leakage current circuit-
breaker (residual current trip).
10. To protect against a risk of electric shock, do not
• INSTALLATION SAFETY
UV HALO DISINFECTION
EXPOSURE METHOD
READ ALL INSTRUCTIONS BEFORE
USING YOUR UNIT
• TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY
WARNING
3
4
UV HALO luminaires use ultraviolet light, destroy
the DNA or RNA of all microorganisms that will be
exposed and remove viruses, bacteria and fungi from
the air. Covered UVC light does not reach the outside
of the lamp. Thanks to stimulated circulation, the air
passes through luminaire interior, where it is exposed
to the light and cleaned, and then pushed outside. UV
HALO luminaires may work in the presence of people.
Only check the operation of the UV-C lamp through
the air vents at the top of the unit. The openings will
light up blue if the lamp is on.
1. Determine where the device will be installed. When
selecting a location for the device, please bear in
mind that the unit must be able to circulate the
air in the room freely and without obstructions.
Also ensure that there is a power socket near the
selected location. Install the device in a dry place.
2. Place the lamp in a disinfected room, if possible
in a central place, to increase the effectiveness
of disinfection. Remember that the disinfection
efficiency in a given place decreases as the
distance from the lamp increases. Never install
the unit in an area subject to full sunlight.
3. Do not cover the luminaire fan, do not place any
objects on the luminaire. In order not to disturb
circulation, leave an empty space and do not put
any objects within 0,5 m of the luminaire fan.
4. There may be people in the room. They can move
freely and do not need protective clothing or
glasses.
5. Do not open the luminaire covers during
its operation. Secure the luminaire against
uncontrolled opening by other people, especially
pay attention to children.
