TOYOTA
TUNDRA D-CAB
2004 -
VSE SUBWOOFER (NON-JBL)
Procedure
(1)
Tuck the wire harness under the B-pillar
cover. (Fig. 8m)
Fig. 8n
Under branch
Fig. 8m
(n)
Route the wire harness along existing vehicle
harness in the front door opening.
(1)
Route the harness under the “branch” in
the vehicle harness. (Fig. 8n)
Fig. 8o
Carpet clip
(2)
Release the white plastic carpet clip and
route wire harness underneath. (Fig. 8o)
(3)
Fasten to the vehicle harness using (3) 7”
wire ties as shown. Trim excess. (Fig. 8o)
(o)
Route wire harness up kick panel
Fig. 8p
Fig. 8s
Fig. 8q
Wire tie
(1)
Insert wire harness into existing clip.
(Fig. 8p)
(2)
Fasten to the vehicle harness using (1) 7”
wire tie as shown. Trim excess. (Fig. 8q)
(3)
Route wire harness behind the dash
bracket, behind the duct and up toward
the glove box opening. (Fig. 8r)
Fig. 8r
Behind
bracket
(p)
From the glove box opening, retrieve wire
from behind the duct. (Fig. 8s)
(1)
Route the wire harness toward the radio
opening
Fig. 8t
Tuck wire
Relay box
Fig. 8u
Relay box
Wire goes
over
(q)
Tuck the wire harness between the HVAC
components. (Fig. 8t)
(r)
Route the wire harness over the relay box.
(Fig. 8u)
(s)
Continue to feed the harness under the duct
and toward the radio opening.
(t)
Retrieve wire harness from bottom right
corner of radio opening.
Fig. 8v
VSE
connector
Vehicle
connector
Fig. 8w
Wire tie
(u)
Connect the wire harness to vehicle radio
harness. (Fig. 8v)
(v)
Wire tie the harness assembly as shown.
(Fig. 8w)
Issue: A 12/15/04
Page 6 of 12 pages
