TOYOTA
TUNDRA D-CAB
2004 -
VSE SUBWOOFER (NON-JBL)
Procedure
(2)
Using an NRT, remove the bolt cover.
(Fig. 7c)
Fig. 7d
Fig. 7c
(3)
Using a 10mm socket, remove the 10mm
bolt that attaches the cab panel. (Fig. 7d)
(4)
Unsnap the cab panel from the cab and
remove from vehicle.
Fig. 7e
Fig. 7g
Fig. 7f
(5)
There are a total of 17 clips attached to
the panel, in the event that any clips
remained attached to the vehicle, remove
them using an approved clip removal tool
and reinstall them to the panel.
(d)
Remove & discard the rear driver side
storage well cover. (Fig. 7e)
(e)
Remove the (4) side X-mas tree fasteners and
discard. (Fig. 7f)
(f)
Remove storage well liner, (3) fasteners and
discard. (Fig. 7g)
8.
Route Wire Harness
Fig. 8b
Fig. 8a
(a)
Place the VSE over the storage well as
shown. (Fig. 8a)
(b)
Route the wire harness through the large hole
on the outside of the storage well. (Fig. 8b)
(c)
Plug wire harness connector into the
connector on the VSE. (Fig. 8c)
Fig. 8d
Fig. 8c
(d)
Move the VSE toward the driver side.
(1)
Pull the slack back through the hole.
(e)
Align the 4 mounting clips on the VSE with
the mounting holes on the vehicle floor, and
apply pressure to the clips to securely fasten.
(Fig. 8d)
Fig. 8e
(f)
Route the wire harness in the rear driver side
foot well and wire tie as shown. (Fig. 8e)
Issue: A 12/15/04
Page 4 of 12 pages
