31
DIAGNOSTICS
BILL ACCEPTOR
Determine if Bill Acceptor has power:
Turn game ON—The bill acceptor should make noise as stacker cycles and
green lights on outside bezel should flash.
If NO power:
Use volt meter to measure 110 AC voltage at cable going into Bill Acceptor from
power strip.
If power is OK:
Clean Bill Acceptor path to make sure there is nothing jamming unit.
Check dipswitch settings on side of acceptor.
Make sure switch # 8 is OFF for Always Enable
ERROR CODES
Count the number of flashes on front bezel of Bill Acceptor and follow chart for repair.
Note: There are many different models and brands of Bill Acceptors that are used on
redemption games. Your Bill Acceptor may differ from the unit shown.
Standard DBA is MEI # AE2451-U5E Part # A5AC9091
Note: If Bill Acceptor is not used, there are 2 blanking plates to be installed to
cover the hole in the front door. Part # A5PL4200 & A5PL8900
Содержание PERFECTION
Страница 1: ...1 SERVICE MANUAL...
Страница 37: ...37 PINOUT AANEWGEN1 PJ RBN...
Страница 41: ...41 DECAL DIAGRAM Decal Diagram...