BAYTEK GAMES PERFECTION, Руководство по обслуживанию

Страница: 26 / 44

26
TROUBLESHOOTING GUIDE
Problem
Probable Cause Remedy
Troubleshooting Guide
Game turns on, but
some of the functions
do not work.
None of inputs work. No coin
up, no test buttons, display
may say communication error. Phone communication cable unplugged or faulty
from NewGen board to motherboard.
Refer to “Communication Error” below.
Game does
not coin up
Game should
have an audio
doink
sound from
speakers when
coin switch is
triggered.
Card Swipe System Special
Instructions-
Pinched, broken, or
disconnected wiring.
Faulty Coin Mechanism. Swap
coin mech to verify.
Faulty NewGen Board
Set “Game drive voltage threshold” to 2 volts. Coin signal
wires are green and black wires. Refer to wiring diagram
Check connections from coin switches to NewGen Board.
Check continuity on wires. (
AACBL4A-DOOR, AACE9704)
Replace coin mech if faulty.
Replace NewGen Board. (AANEWGEN1-PJ/RBN)
Low tickets
displays on
monitor
The error has a
5 second delay
in clearing and
coming on.
Stack of tickets not resting
properly on low ticket switch.
Faulty switch.
Faulty wire or connection.
Faulty NewGen Board
Adjust stack of tickets so they hold both the switch
actuators down.
Replace low ticket switch. (AASW200)
Check for proper connection from switch to main
board. Check continuity. (AACE9700)
Replace NewGen Board. (AANEWGEN1-PJ/RBN)
Communication Error
Check Newgen Comm
Error
Game does not coin up
but credit meter clicks
.
Main Board and wiring to
coin switch OK.
If “Power” is not solid ON
Ensure AACE9712 cable is
plugged to blue “IN” socket on
board.(J16) Replace if needed
Replace NewGen board.
(AANEWGEN1-PJ/RBN)
If “TX” & “RX” are not blinking very fast
Communication from Motherboard faulty.
Check AACE9713 to motherboard.
Check or replace adaptor (A5CN1031)
Replace Comm Board (AACB2204A)
Replace motherboard (AAMB9A-HD)
Check green LED’s on Serial Interface board.
Is “Power” solid ON?
Is “TX” & “RX” blinking very fast?
RX is receiver communication from Newgen Board.
It should be flashing rapidly and dim.
TX is transmitter communication from Motherboard.
It should be flashing rapidly and dim.
Power comes from Newgen Board.
LED should be on if power is on.
AACB2204A
Interface Board
AANEWGEN1-PJ/RBN