BAYTEK GAMES PERFECTION, Руководство по обслуживанию

Страница: 11 / 44

11
MARQUEE UPDATE INSTRUCTIONS
7.) Locate the 5 cables in the new Marquee and push them down through the hole
into the lower cabinet.
8.) Connect these cables into the cabinet wiring as:
8708 cable to 9731 cable
9709 ribbon cable to the splitter board
9707 cable to a power supply connector
9705 cable to the Newgen speaker socket
9737 cable to the J22 socket on the Newgen Board.
9.) Install new software into Motherboard:
Remove old SATA drive located in top right corner of motherboard by
gently squeezing bottom metal of SATA drive and pulling straight off
motherboard.
Remove the small black and red wire from old SATA drive
Install the small black and red wire into the new SATA drive
Install new SATA software into motherboard by pushing gently straight into
motherboard.
Ensure the power is off to the game.
Important: If only power supply is off, but power strip is on, the mother
board is still receiving power from the TV through the HDMI cable.
It will not power on correctly until entire game is turned off for 5 minutes.
10.) Turn on game by plugging it into the wall.
11.) Newgen Software Installation - With game power ON -
Insert USB update stick into Minigen socket on left edge of board.
Press “Boot” button on Minigen located near dipswitches.
Update will take a few seconds.
The top display will go blank, and come back after loading is complete.
12.) Update is complete. Enter menu to change to desired game options.
Test game to verify correct settings.
If you have any questions or need further assistance please contact Bay Tek Games at 920-822-3951 ext. 1102