Page
42
Cascade Mode
Menu 4: Network Cascade Mode
Cascade Mode Enable
Cascade Mode Status Display
Command Confirmation
Enter Request :3
Command Confirmation is.......... Enabled
Enable ? (Y/N), CR for no change) :
Enter Request :2
RPC Outlet Status Display is..... Enabled
Enable ? (Y/N), CR for no change) :
Mode Menu
Cascade mode: Enabled
Outlet Status Display: Enabled
Command Confirmation: Enabled
Cascade Mode Enable..............1
Cascade Mode Status Display......2
Command Confirmation.............3
Select 2),
to enable this unit to display both
the Master/Slave outlets:
Select 3),
to enable the unit to ask for
confirmation before executing the command
Select 8), from the RPC Management Menu,
to
allow a user to connect to a non-Ethernet Baytech
power strip to control outlets of both units from
one menu.
Select 1),
to enable the Cascade feature
NOTE:
Read the instruction carefully for the feature to operate properly.
RPC Cascade Mode is.............. Enabled
Enabling this feature will allow access and management of a BayTech Remote
Power Device through the console (EIA-232) port via telnet/ssh/SNMP/http.
In RPC Cascade Mode, normal console port terminal service will operate only
when the network cable is disconnected.
When Cascade Mode is changed, URPC module will *RESET* upon acceptance of
configuration changes, at which time, cascade device should be connected
to or disconnected from the EIA-232 port as appropriate.
Enable ? (Y/N), CR for no change) :
Module: 1
Attention Character:
MMP05 (2 ,1).........1
Master Unit Outlet Controller
MMP05 (2 ,2).........2
Slave Unit Outlet Controller
Outlet Group Control............O
Combined Master Slave Outlet Control
Status..........................S
Unit network Status
Configure.......................C
Unit Configuration menu
Unit Reset......................RU
Terminates external connections,
does
not
affect
outlet
states.
Logout..........................T
Terminates terminal session to unit
Enter Request :s
With Cascade enabled and the unit resets, two options are added to the Network Menu, Option “2”
for the slave unit and option “O” for Outlet Group Control. Option “2” gains access to the slave unit
through the RS232 port.
