Still have questions? Contact Barbour International, Inc. customer
service at
1-800-736-8028
, or visit
www.thebayou.com
TROUBLE-SHOOTING
Burner will not light
Burner lights, but has
very small/poor quality
(sooty) flame
Flame dramatically
reduces, and LP cylinder
has frost on it.
Hissing or gurgling
sounds coming from
appliance
Flame has gone out
Symptom
Cause
Possible Solution
Obstruction in the burner
LP tank has low fuel
LP tank has low fuel
Too windy
Gas Flow Limiting Device has
activated
Extended cooking on HIGH
Damaged or leaking hose and
regulator assembly
Not enough gas flow from tank
Part of appliance is damaged
Inspect burner. Wash out and dry if necessary.
Use a tank fill gauge to always know gas level.
If gas is too low to operate, refill or exchange tank.
Use a tank fill gauge to always know gas level.
If gas is too low to operate, refill or exchange tank.
Check wind direction and wait for wind to die down,
or move appliance away from windy areas.
Completely turn off (close) the LP Cylinder Valve
and the Control Knob to prevent any gas flow. Wait
30 seconds and repeat steps for lighting.
Swap to a full LP tank. If you continue cooking with
the same LP tank, stop cooking for a few minutes and
then start again operating at MEDIUM setting.
Turn appliance off, and wait for it to cool down.
Perform Gas Leak Test to confirm gas leak. Replace
any damaged or faulty parts.
Turn up (open) LP Cylinder Valve all the way.
Inspect LP tank, burner, and HVR assembly for
damage. Replace any damaged or faulty parts.
Moisture in the burner
Turn appliance off, and wait for it to cool down.
Inspect burner and pour out water.
Poor oxygen/gas mixture
Adjust air shutter to obtain optimum blue flame.
• Remove batteries from product after each use to prevent corrosion
or leaking.
• Always turn off (close) the gas supply and disconnect the hose
and regulator from the LP cylinder to move or store.
• To avoid damage to the regulator, use the wire hook provided to
hang regulator on the appliance frame any time the hose is not
connected to the LP Cylinder.
• Store appliance in a dry place. If storing indoors (including
a shed or garage), detach the LP cylinder and store the tank
outside. For long term storage, cover the burner and the HVR with
a plastic bag.
• Do not store this appliance, or any of its components, in a corrosive environment. A corrosive environment can
be a highly damp area, or a saltwater/marine environment.
• Metal discoloration will result from exposure to excessive heat. For hard to clean stains or discoloration of a
cooking vessel, apply a non-abrasive cleaner with a clean, damp sponge or cloth. Do not use a steel wool pad
or harsh abrasive cleanser as scratching will occur.
Hang regulator
to frame with
wire hook
