Page 13
6.4.1
Locating the burner.
z
Place the burner assembly in position (If installing into a 'Spanish Basket' casting it is important that the
burner tray trim touches the inner front face of the casting. This will give the customer greater access to
the control knob.
z
Mark on the fireplace floor the position of the fixing holes in the bracket that is attached to the rear of
the front leg. There are two holes in this bracket to prevent burner movement in use (See
figure 6
).
Figure 6. Locating the burner
z
Remove the burner assembly.
z
Using a 6mm masonry drill, drill into the hearth at the marked position.
z
Insert the supplied screw plugs.
z
Remove the fixing bracket from the front leg by removing the screw.
z
Place the bracket in position on the fireplace floor and fix in position using the woodscrews provided.
z
Place the burner assembly back in position and attach to the bracket by refitting the screw.
7. BURNER AND SUPPLY PIPE INSTALLATION
A nut and olive is provided for an 8mm-pipe inlet connection directly to the inlet 'T' connector which can be
rotated to allow a connection from any direction. The inlet 'T' connector includes a valve for isolating the gas
supply and its centre is 25mm above the fireplace floor. It should be fitted to the supply pipe at this stage.
The supply pipe must be rigid material. Flexible pipe must not be used. Connect the supply line to the
appliance.
Turn on the gas supply and pressure check the installation pipework for gas soundness.
In the United Kingdom (GB) check in accordance with the current edition of BS 6891.
In the Republic of Ireland check in accordance with the current edition of IS 813 "Domestic Gas Installations".
Page 12 of 25
20/08/2012
http://www.partsarena.com/baxi/System/DATA/Dx/DS1/installation/2642/I39-2642/I...
