Hyper-D Series
Installation Instructions
4
PRODUCT SAFETY
Installation and servicing is only to be carried out by suitably qualified and
experienced personnel to local or national wiring standards.
Good engineering practice must be carried out at all times and all servicing and
repairs carried out indoors.
Hyper-D series cameras are to be powered with a class 2 power supply.
Under no circumstances must the power consumption of the Auto Iris connector
exceed 50 mA or the Direct Drive connector exceed 25 mA.
The Hyper-D range is designed for use in general purpose CCTV applications
and has no other purpose.
Only operate your camera between the temperatures of -10
O
C and +50
O
C.
In order to avoid damaging the camera note the following points.
1) Before fitting the lens make sure that its back will not touch the sensor or
associated components when screwed fully home.
2) Do not touch the image-surface of the sensor. If the sensor is accidentally
touched, only clean it using ethyl alcohol.
3) Do not expose the sensor to direct sunlight as this may impair the performance
of the camera.
4) For outdoor use, an appropriate protective housing conforming to IP65 or UL50
or better must be used.
MANUFACTURERS DECLARATION OF CONFORMANCE
The manufacturer declares that the equipment supplied with this manual is compliant with
the essential protection requirements of the EMC directive 89/336/EEC and the CE Marking
Directive 93/68 EEC. The equipment conforms to the requirements of standards
BSEN61000-6-3:2001 for Emissions, BSEN50130-4:1996 (with amendments A1 and A2)
for Immunity and BSEN60950:2002 for Electrical Equipment Safety.
ELECTROMAGNETIC COMPATIBILITY (EMC)
This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
This product is intended solely for use in general CCTV applications.
The product must be installed and maintained in accordance with good installation practice
to enable the product to function as intended and to prevent problems. Refer to your agent
for installation guidance.
