Bavis TransTrax, Инструкция по установке и обслуживанию

Страница: 12 / 28

8
Power Connection:
The AC Line connection is at the top of the
INSIDE VERTICAL STANDOFF . Connection method
should comply with all authorities having jurisdiction, (i.e. National, State or Local Electrical
Codes). A 1/2" knockout is provided on a single gang box cover. Removing the cover will reveal
three leads for termination.
The white wire is the neutral.
The black wire is the hot. (Single phase 120vac)
Green is for ground.
NOTE: To reduce the risk of shock hazard of both line voltage and static, the ground must be
connected to a good earth ground.
The wiring can be enclosed in flexible metallic or nonmetallic conduit. If a cord connection is
acceptable, one is provided in the kit complete with a romex connector.
NOTE: On the supplied
cord the ribbed wire is the neutral connection and the smooth wire is the HOT. Please reduce the
cord to a minimum length before connecting. Do not use an extension cord for permanent wiring
and do not run the cord through or conceal in walls, ceilings and or other permanent fixtures.
Press the
POWER BUTTON once. The LED above it should come on indicating that the unit has
power. Pressing it again should toggle the power off.
Installing Tape:
NOTE: The AC power must be on to install the tape as this machine has a mechanical brake
that requires power to release
.
Remove the CUSTOMER SPEAKER PANEL . Feed the TAPE into the tape slot at the CUSTOMER
SPEAKER OPENING insuring that it pushes smoothly all the way into the power unit of the
INSIDE VERTICAL UNIT . Cut the tape two feet longer than this dimension. Remove the tape and
dress the ends
9
. Attach the CARRIER to the TAPE
10
. Before reinserting the prepared tape with
CARRIER attached, take a section of the discarded tape (two feet will do) with square cut ends and
run it through the system by hand with a screwdriver. If any rough spots or obstructions exist,
correct them before proceeding. Reinsert the
TAPE into the tape slot. At the INSIDE VERTICAL
UNIT , Press and hold the brake release while inserting the tape. Note that the LED comes on.
_____________________
9 Fig.5
10
Fig.6