Bavis TransTrax, Инструкция по установке и обслуживанию

Страница: 11 / 28

7
The FORMED RADIUS needs to be attached to the CUSTOMER VERTICAL UNIT using the
extruded internal SPLICE PLATES
6
.
The
HORIZONTAL TUBING needs to be cut to a dimension which will allow both of the vertical
units to be plumb vertically after it is installed to the FORMED RADII . Be sure to deburr and
chamfer each end of the tubing
1
before proceeding.
Airlock Assembly:
The
AIRLOCK ASSEMBLY is a two-piece design. Attach the AIRLOCK BOTTOM using the self
drilling screws provided
8
. Note the alignment tabs on this part that center it on the tube. The
notched end goes on the radius. Install the AIRLOCK TOP to the BOTTOM. Fill the area between
the AIRLOCK ASSEMBLY and the 16" x 24" opening with insulating material and cover with
drywall, sheathing board or other appropriate material.
Ceiling Trims:
Secure the
CEILING TRIM halves together around the TransTrax
®
tube with the #8-32 hardware
provided. Holes must be predrilled with the short 9/64" bit provided in the installation accessories
to prevent drilling into and damaging wiring. Attach the ceiling trim to the tubing of the
TransTrax
®
with the #8x1/4" self-tapping screws provided. These screws do not protrude into the
tubing greatly simplifying running the wiring. Note: The trim must be on the vertical section of
tubing, not the radius. If it is necessary to attach the trim to the ceiling, it will be necessary to drill
holes for this purpose, as there are no holes provided for this. Test the machine to insure that there
is nothing preventing the car from traveling through the flaps.
NOTE:
CEILING TRIMS are designed to be mounted on the vertical tube and are not designed
to be mounted on the FORMED RADIUS. When installing trims, make sure that the CAR moves
freely through the trim and does not rub or bump the sides of this component.
Note that six 1" angled reinforcement plates are included in the installation accessories of each
TransTrax
®
. These are intended to be used when installing the ceiling trims and airlocks when it is
not possible to get fasteners in from the bottom of the tube or the sides. Simply attach the angle to
the airlock bottom or ceiling trim back and then the side of the tube.
_______________________
6 Fig. 2
7
Fig. 2
8 See Drawing on page 3