Baumuller BUM 60, Инструкция по эксплуатации

Страница: 45 / 84

Installation
Instruction handbook BUM 60 / BUS 60
Document No.: 5.01032.05
45
of 82
7
7.2 Voltage test
DANGER!
Risk of fatal injury from electrical current!
During the routine test of these devices, a voltage test is performed by Baumüller
Nürnberg GmbH in accordance with EN 61800-5-1, Section 5.2.3.2. It is thus unnec-
essary for the customer to do this.
Therefore:
m
Subsequent tests of the devices using high voltages may only be performed by
Baumüller Nürnberg GmbH.
m
Disconnect the converter from the system during high-voltage testing!
7.3 Requirements to the supply system
For all important data, see
Z
Requirements to the energy supply / supply system
–
from page 25.
Minor deviations from requirements in the power supply can lead to malfunctioning of the de-
vice. If the power supply deviates too much from the requirements, the device can be destroyed.
The devices may only be operated in industrial networks.
The destruction of the device can cause personal injury.
DANGER!
Risk of fatal injury from electrical current!
If the requirements for the power supply are not complied, the device can be dam-
aged or destroyed, thereby greatly endangering individuals.
Therefore:
m
Prior to installation, ensure that the demands for power supply have been fulfilled.
7.4 Requirements to the connecting cables
h
Take into account IEC/EN 60204-1, Chapter 13 when selecting the cable.
h
The protective ground cross-section of the cable must be compliant with IEC/EN 60204-1,
Section 5.2, Tab. 1.
h
A fixed connection for the protective ground conductor is mandatorily specified for operation
of the device.
h
Use copper cable approved for a minimum of 60 °C (drives < 3 x 100 A) or 75 °C (drives
≥
3
x 100 A), if comply with UL 508C.