Baumuller BUM 60, Инструкция по эксплуатации

Страница: 39 / 84

Mounting
Instruction handbook BUM 60 / BUS 60
Document No.: 5.01032.05
39
of 82
6
6.2 Preparing for mounting
Based on the planning documents and the drilling pattern, the cutout sections and the positions
of the attachment drill holes can be determined.
NOTICE!
Property damage due to conductive contamination.
Therefore:
m
When performing installation work of any kind, it must be ensured that no foreign
material (e.g. drill shavings, copper strands, etc.) gets into the device as a result.
m
If possible, the drilling of the holes should be done before mounting the device and
the configuring of the cables should take place outside of the control cabinet. If this
is not possible, the device must be appropriately covered.
Remove this covering again prior to start!
CAUTION!
Eye injury due to flung particles.
Metal particles are flung when making the drill holes and the cutout sections.
Therefore:
Wear protective eye wear!
h
Preparing drill holes and cutout sections.