check the pump.
The appliance
does not solder
the bags
1)
Dirty contacts.
2)
Soldering
resistance bar
broken.
3)
Power shortage.
4)
3-way electro
valve blocked or
dirty.
1)
Remove the soldering bar
from the two screws and
clean the two bar contact
holes with a small brush.
2)
Technician required to
change the bar.
3)
Technician required to
check the leads and power
board.
4)
Technician required to
replace valve.
IMPORTANT: If your appliance appears not to be
operating correctly, then you should disconnect it
from your mains supply and then contact
Baumatic Customer Care on telephone number
(0118) 933 6911.
DO NOT ATTEMPT TO REPAIR THE APPLIANCE
YOURSELF.
Please note that if an engineer is asked to attend whilst the product is
under guarantee and finds that the problem is not the result of an
appliance fault, then you may be liable for the cost of the call out
charge.
The appliance must be accessible for the engineer to perform
any necessary repair. If your appliance is installed in such a
way that an engineer is concerned that damage will be caused
to the appliance or your kitchen, then he will not complete a
repair.
This includes situations where appliances have been tiled in,
sealed in with sealant, have wooden obstructions placed in
front of the appliance, like plinths. Or any installation other
than the one specified by Baumatic Ltd. has been completed.
Please refer to the conditions of guarantee that appear on the
warranty card that you receive with the appliance.
37