Stopping a cycle in progress
o
By pressing the stop button, an acoustic signal will
warn you that the cycle will be immediately
interrupted. In this case, the appliance will
not
carry
out the soldering phase and the chamber will be decompressed.
o
After the discharge phase all the LED’s will revert to the initial
start-up mode.
Cleaning and maintenance
WARNING: PLEASE ENSURE THAT YOUR
APPLIANCE IS DISCONNECTED FROM
YOUR MAINS SUPPLY BEFORE
ATTEMPTING TO CLEAN IT.
o
Do not clean the appliance by pouring water onto it or spraying
water over it.
o
Clean the containers separately with soap and water.
o
Do not use abrasive products, detergents or soaps. Do not
scrape the surface with sharp objects.
o
After washing the appliance, wipe over the area that you have
cleaned with a damp cloth and then dry it carefully and
thoroughly.
Cleaning the external surfaces
o
The external surfaces of the vacuum-packer are made of
stainless steel and should be cleaned with a soft cloth or a
sponge and neutral detergent.
o
After cleaning it is advisable to protect the external surfaces with
specific oil-based products for stainless steel.
During cleaning do not remove the matriculation plate. It
provides important information on the device for the service
centre.
o
The control panel has “soft-touch” commands that do not use
protruding buttons. Therefore, an appropriate cleaning product
for glass surfaces is suitable for cleaning the control panel. Use
a soft cloth with only a little detergent and carefully dry.
21