Bartscher Eros 3 R/F, Инструкция по эксплуатации

Страница: 36 / 52

10
5. Cleaning and Maintenance
WARNING:
Before any cleaning operation unplug the device from the electrical
system. Never wash the appliance with water jets in order to prevent
water seepage inside the electrical
components.
Clean the appliance at the end of the service. The
tank has to be emptied from the condensation
through the drain cock (see image on the right). Place
a bucket under the drain cock and turn the lever,
make sure it is closed once the tank will be empty.
Once the tank will be empty, it is recommended to dry
it up with a cloth or a sponge.
The laminate parts can be cleaned with a damp cloth-
In case of stubborn stains, use a damp cloth with
some alcohol, do never use corrosive or abrasive detergents.
The manufacturer is not responsible of any structural damage caused
by the use of damaging substances.
The trolley must always stand horizontally and shall never be turned to
prevent damages on the compressor.
5.1 Breakdowns
Problem Possible Reasons Solutions
The trolley does not cool
Power failure
Check the power presence in the
electric system
Lack and/or loss of gas from the system Contact the retailer
The thermostat is broken Contact the retailer
The power cable is worned out
Replace the cable with a suitable
one
The neon lamp does not light
up
The lamp is burned
Replace the lamps with the
suitable same ones
The switch is turned on “off”
Pull down the dome and turn the
neon power switch placed on the
side.
Drain cock