Pag. 33/50
Electric fry top (fig. 17 – pag. 6)
To light the fry top, proceed in the following way:
-
Turn the knob (1) of the thermostat into the position which corresponds to the cooking
temperature desired; the two lights come on, the green light stays on all the time to show that
there is tension, whilst the orange one goes off as soon as the hotplates reach the desired
temperature.
To turn off the hotplate turn the knob into the 0 position.
ATTENTION! Only use the appliance under surveillance. Never let the hotplates function
with nothing on them.
Abnormal functioning
If for any reason, the appliance does not start up or stops working during use, check that the
energy supply and the control knobs are set correctly; if all is regular, call customer service.
Some problems and possible solutions
Problem
Possible solution
The pilot burner does not light on
-
Check that gas inlet pressure is the same as that shown in
table at page 29
-
Check that the nozzle of pilot burner is not blocked
-
Check that the igniter plug is well fixed and connected
-
Check that the igniter plug is intact
-
Check that the igniter cable is intact
-
Check that the piezoelectric igniter is intact and
functions correctly
-
Check the gas valve
The pilot burner lights off after
loosening the igniter knob
-
Check that gas inlet pressure is the same as that shown in
table at page 29
-
Check that the flame of the pilot burner laps the
thermocouple; if this is not the case, adjust the pilot
burner through the regulating screw on the valve
-
Press the gas knob in its correct position
-
Change the thermocouple
-
Check if the valve magnetic group is rusted
-
Check the gas valve
The pilot burner stays on but the main
burner does not light on
-
Check that gas inlet pressure is the same as that shown in
table at page 29
-
Check that the gas nozzles are not blocked
-
Check that the burner holes are not blocked
-
Check that the gas pipe is not blocked
-
Check that the nozzles installed are in accordance to
table 2-3-4-5-6-7-8-9-10
-
Check the gas valve
Slow and/or inadequate heating
-
Check that gas inlet pressure is the same as that shown in
table at page 28
-
Check that the nozzles installed are in accordance to
table 2-3-4-5-6-7-8-9-10
-
Check the gas valve
