Pag. 32/50
Substituting the burner nozzle (fig. 12, 13 – pag. 5)
To substitute the nozzle of the burner, first of all it is necessary to remove the knob (1), the drip
pan (2), and the control panel (3). After clearing the work area, loosen the screw which blocks the
primary air regulating bush (5) and open it completely; unscrew the nozzle (6) with a spanner and
substitute it with a suitable nozzle for the type of gas used, shown in tables 2, 3, 4, 5, 6 (pag. 23,
24). Reassemble the nozzle,, tightening it well and proceed with regulating the primary air, as
indicated in the next paragraph. When all this is done, replace the parts removed previously.
Regulating the primary air of the burner (fig. 13 – pag. 5)
After having substituted the burner nozzle, the primary air must be regulated; to do this, loosen the
screw (4) which fixes the bush (5), bring value X to the correct measurement, referring to tables 2,
3, 4, 5, 6 (pag. 23, 24), tighten the screw (4) and check the accuracy of value X.
Substituting the By-Pass (fig. 12, 14 – pag. 5)
To substitute the by-pass, firstly the knobs (1) must be removed and then the drip pan (2). When the
work area is clear, unscrew the by-pass (7) with a screwdriver and substitute it with the by-pass
suitable for the type of gas to be used, shown in tables 2, 3, 4, 5, 6 (pag. 23, 24). Reassemble the by-
pass and tighten it well.
Put back the control panel, the drip pan and the knobs.
Substituting the pilot burner nozzle (fig. 15 – pag. 5)
To substitute the nozzle of the pilot burner, first of all, the knobs (1) must be removed, the drip pan
(2) and the control panel (3), as in figure 14. Unscrew the fitting (8) which fixes the gas supply pipe
of the pilot (9) and remove the nozzle (10). Substitute it with the nozzle suitable for the type of gas
to be used, shown in tables 2, 3, 4, 5, 6 (pag. 23, 24). Then proceed to assemble the new nozzle,
reposition the pipe and tighten the fitting fully. When all this has been done, put back the parts
removed previously.
INSTRUCTIONS FOR USE
Gas fry top (fig. 16 – pag. 6)
To light the burner of the fry top, proceed in the following way:
-
turn the knob (1) from the off position
●
into the on position ;
-
press down to the bottom;
-
push the button of the piezoelectric lighter (2) to light the pilot burner;
-
keep the knob pressed down until the thermocouple heats up, keeping the pilot lit; this can be
checked through the slit in the control panel;
-
light the main burner, positioning the knob in one of the eight possible positions, choosing the
one most suited to the type of cooking desired, considering that they correspond indicatively to
the temperatures shown below:
To put out the main burner, it is necessary to turn the knob to the right into the on position , to
put out also the pilot, turn the knob again into the off position
●
.
Po sition [N°]
1
2
3
4
5
6
7
8
Tem pe ra tur e [°C]
1 70
19 0
2 10
2 50
27 0
29 0
3 05
3 30
