Bartec Wireless X BPXWXU1, Руководство пользователя

Страница: 10 / 34

10
1.
Remove Ex e lid and
insert cables into glands
Unscrew the 7 M6x1 fasteners
and remove the Ex e lid to
access the power and network
interfaces.
Follow the mounting instructions
of the cable glands thoroughly.
2.
3.
Unscrew the cover protecting
the fiber splice tray and also
the smaller cover over the slot
you plan to splice the fiber
cable in.
Preparing the fiber
splice tray
Identify the RX and TX cables
(marked with a sticker) Make
sure to splice accordingly.
Prepare the fiber - Strip the
protective coatings, jackets,
tubes, strength members, etc.
leaving only the bare fiber
showing. Make sure that fiber
surface area is clean.
Splicing fiber
Always pay attention to the fiber cables’ minimum bend radius of 30 mm.
If you bend the fiber cable tighter than this minimum bend radius, you risk
breaking the fiber cable.
FIBER VERSION (FIB)
Follow the cabling and termination instructions below for correct installation. Lay out the parts,
cables and components as shown in the illustrations. It's recommended to use the included
dome fixture during the cabling and termination process.
Installation