Operation and Installation Manual PBTC-200-E
21-54C3-7D0001/A
05/2023-EHT-441168
Notice:
Technical data subject to change without notice.
No claims for damage arising from alternations, errors or misprints shall be allowed.
Page 19 / 40
Slide the top unit of the mounting stand over the trace
heater(s).
Slightly tighten the 4 fixing screws using a hex wrench. Do
not tighten them fully yet to allow the trace heaters to be
moved.
Preparing the Heating Cable
Remove 145 mm of the outer jacket on the end of the trace
heater.
Push the grounding braid back. Use the screwdriver to form
an eyelet. Be careful not to damage the internal insulation
jacket.
Bend the trace heater and pull the heating element out of
the grounding braid.
Twist the grounding braid in order to form a pigtail.
6
7
8
9
10
