Baroness LM3210A, Руководство по эксплуатации для владельца, Страница: 100 / 167

Cutting Work
Cutting Work
Caution
Be sure to operate at an appropriate speed for
the mowing site.
When cutting over bumpy surfaces, keep the
engine rpm steady, and slow down the cutting
speed.
Caution
Note that if you stop operating the mower unit
up/down lever before the mower units are
raised completely, reel rotation may not stop.
Reel rotation will be turned on or off based on
the sensor-detected position of the mower
units.
Important
Do NOT start to move or stop the machine
abruptly.
It will damage the hydraulic system or result in
oil leakage.
Release the mower lock levers (latches) for
mower units #4 and #5 just before cutting
work.
Start the engine.
"Procedure to Start Engine" (Page 5-18)
Firmly depress the brake pedal to release
the locking pedal for releasing the locked
brake pedal.
Shift the throttle knob to rev the engine up to
the maximum rpm.
Shift the mower unit up/down lever to the
"Down" position to lower the mower units.
Set the reel rotation switch to the "Rotation"
position to rotate the reel cutters (cutting
cylinders) of all mower units.
Depress the traveling pedal to start cutting
work.
Note:
During the work, the reel cutters (cutting
cylinders) will rotate or stop in sync with the up
and down motion of the mower units.
1.
2.
3.
4.
5.
6.
7.
Transporting
Transporting Procedure
When loading the machine into a trailer or a
truck to transport it, drive the machine forward.
When unloading, drive the machine in reverse.
If the roof is installed on the machine, remove
it.
The roof may be damaged by wind pressure.
LM3210A
Handling Instructions
Page 5-20
Cutting Work