Barnett Engineering ProTalk Plus B1290, Руководство по эксплуатации, Страница: 52 / 82

followed by the message repeated twice. In this case the entry for each of
the radio related commands would be:
B1290: Directory A, Line One is...
YOU:
#1 #3 #8 #8 **
[RADIO][ALERT] [VOICE][VOICE]
B1290: Directory A, Line One is RADIO ALERT VOICE VOICE
Over the telephone, the message will be repeated only once.
If this programming is used, when the B1290 registers an alarm, the report-
ing cycle will be as follows:
Over radio: Alert tone
Ajax Compressor Station; Power Failure
Ajax Compressor Station; Power Failure
Enter Acknowledge Code
pause for 2 minutes
Alert tone
Ajax Compressor Station; Power Failure
Ajax Compressor Station; Power Failure
Enter Acknowledge Code
pause for 2 minutes
Alert tone
Ajax Compressor Station; Power Failure
Ajax Compressor Station; Power Failure
Enter Acknowledge Code
pause for 2 minutes
Over telephone: dial 2559544
Ajax Compressor Station; Power Failure
Enter Acknowledge Code
pause for 5 seconds -waiting for acknowledge code
Ajax Compressor Station; Power Failure
Enter Acknowledge Code
pause for 5 seconds -waiting for acknowledge code
This sequence repeats for 60 seconds.
If the Acknowledge Code is not received over the telephone, the B1290 will
wait ten minutes and try the complete sequence again, starting with the ra-
dio cycle. If no Acknowledge Code is received after six tries at ten minute
intervals, the B1290 will switch to reporting every hour until the alarm is ac-
knowledged.
51 Programming Examples