BARMATIC COOLICE ICE250, Руководство пользователя

Страница: 12 / 28

12
EN
Cleaning of the Ice Storage Bin
• To clean the ice bin, first turn the power switch to
the “Off” position. Then disconnect the product
from the main power supply.
• Drain the ice completely from the ice bin.
• Wipe the inside of the ice bin with cleaning solu-
tion / soapy cloth and then rinse / dry.
• Take care not to allow any lime and/or cleaning
solution residue to remain.
Cleaning of the Water Inlet Filter
• Disconnect the Ice Maker from main power
supply.
• Disconnect the water connection of your ice
maker.
• Remove the water inlet filter. (The frequency of
cartridge replacement varies depending on the
usage period, but it is recommended to change
every 6 months.).
• Follow the filter manufacturer’s maintenance
and cleaning instructions / recommendations to
perform cleaning and maintenance of the water
inlet filter.
NOTE:
Then return the Ice Maker to operation by
following the installation instructions.
IMPORTANT: The applications specified in the
product cleaning instructions should be performed
at least 4-5 times a year.
13. Troubleshooting
Fault Probable Cause Solution
Ice Maker does not work
Power button is Off. Set the power button to the “On” position.
The power connection is faulty. Get the power connection checked by a
qualified electrician.
The Ice Maker is in protection mode. Check the place selection instructions of the
ice maker. Ice Maker does not receive
adequate amount of air.
No power in the outlet. Check the fuse connected to the outlet.
The compressor stops
shortly after it starts
working Ambient temperature is very high. Check the place selection instructions of the
ice maker. Ice Maker does not receive
adequate amount of air. Clean the ventilation
filter.
Grid voltage is low. Get the power connection checked by a
qualified electrician.
Ice Set is cooled but the
water inside the water
pool is insufficient Water valve is faulty Contact the nearest Authorized Service.
Water supply pressure is low Make sure that the water supply pressure is
greater than 1 Bar.
Water level drain plastic group seeps Place the water level plastic group to its slot
tightly.
Ice cubes are not
transparent Water nozzle is blocked Water nozzle sprayer should be checked. The
blocked nozzles should be cleaned.
Water pool is dirty Clean the Ice Maker by following the cleaning
instructions.
Pressure of the water pump is low Contact the nearest Authorized Service.
The water is blurry / dirty / chlorinated Use a water filter.