BARMATIC COOLICE ICE250, Руководство пользователя

Страница: 11 / 28

11
EN
There are some malfunction and warning signals defined for the Red light on the power button of the prod-
uct as detailed in the chart below.
Function mode ON OFF
Cleaning 3 sec 1 sec
Fault 2 sec 2 sec
Ice Bin Full 1 sec 1 sec
Cleaning and maintenance
NOTE:
Safety rules must be observed before clean-
ing your Ice Maker.
• Unless otherwise specified, turn off and unplug
the unit before starting to clean the Ice Maker.
• The outer cabinet of the product should only
be cleaned by wiping with a damp cloth. Do not
spray the unit with water or any other cleaning
solvent. This causes undesired electrical failures
and jeopardizes the safety of the user.
• Always wear protective gloves and similar pro-
tective equipment during cleaning.
• Never use cleaning agents and chemicals which
may cause cutting, piercing and corrosion to
your product. Your Ice Maker will be out of war-
ranty if chemicals are used for cleaning.
• Do not use any cleaning agents not recommend-
ed by your Authorized Service.
Exterior cleaning of the Ice Maker
The exterior of your ice-maker is made of stain-
less steel. Wipe the exterior surfaces with a cotton damp cloth or a sponge and then wipe it with a dry,
clean cotton cloth.
Cleaning of the Sprayer System
• Make sure the water and electrical connections
of the product are off, in compliance with the
cleaning instructions above.
• Remove all the ice from the storage bin.
• The power switch should be off, and the water
inlet valve should be opened.
• Remove the slide grate located inside the inner
basin and then remove the level discharge plas-
tic from its slot, and ensure the water to be dis-
charged. (See Figure-3)
• Place the water level drain plastic group back
to its slot after discharging the water inside the
pool. (See Figure-4)
• Then, pour the cleaning solution recommended
by Authorized Service into the water pool.
• Select the ‘cleaning’ setting on your product,
then turn the power switch to the “On” position.
WITHIN 30 SEC OF TURNING ON THE POWER,
YOU MUST PRESS AND HOLD THE ‘CLEANING’
BUTTON FOR 9 SEC. (See Figure-5)
• The cleaning process will continue for 10
minutes.
• At the end of the cleaning cycle, remove all the
produced ice from storage bin.
IMPORTANT:
Do not turn off the product while
cleaning is in progress. After the cleaning process,
discharge the water inside the inner basin. (See
figure 3)
NOTE: Right after this cleaning, the Ice Set must
be cleaned
Cleaning of the Ice Set
To remove the top cover, remove the screws in “Fig-
ure-6”. Remove the plastic cover on the cooling
pipes. Clean the cooling pipes and visible surfac-
es in the tank with cleaning solution / soapy cloth. Then rinse and then dry. Close the plastic cover
that protects the cooling system pipes and then
close the top cover of the product. Then replace the
screws.