4-1
5975978 RETRO GRAPHICS 2100 220198
Enabling/Disabling the Password
How to Enable or Disable the Password
How to change the Password Menu
How to Enable or Disable the Password
It is necessary to remove the projector from the lower cabinet to
perform the changing of the pass word function. Follow the procedure
for
'Removing the Projector'
shown in the preceding chapter.
It is necessary to remove the metal cover plate behind which the
password strap plug sits. To achieve this remove the four fixing
screws and carefully lift clear the cover plate. The password strap
on the controller circuit board module will now be visible.
The password function is enabled/disabled when the password
strap plug on the controller circuit board module is installed in the
following specified way. To get access to the controller circuit board
module, proceed as follows;
a. Place the projector on a stable solid surface in preparation for
altering its password strap plug. Remove the left side (when facing
the lens) fixing bracket of the projector by unscrewing its two fixing
bolts.
Remove the top cover by loosening or undoing its fixing screws (as
shown earlier.) Then slide the cover backwards slightly and lift off,
the internal structure will now be visible.
Place the projector on a stable solid surface in preparation for
altering its password strap plug. All the fixing screws for the top
cover are indicated and are required to be removed or loosened in
step
a.
ENABLING/DISABLING THE PASSWORD
4
PROJECTOR
FIXING
BRACKET
PROJECTOR
FIXING BRACKET
SCREWS
PROJECTOR
TOP
COVER
a
METAL
COVER
PLATE
PROJECTOR
TOP COVER
SCREWS
PROJECTOR
TOP
COVER
