3-7
5975978 RETRO GRAPHICS 2100 220198
Power Up Considerations
a To switch between 120V AC and 230V AC all that is required is
to
unplug the selector plug and turn it around
, the plug is in the
120V position.
Once the voltage has been chosen it is necessary to re-insert the two
disconnected power wires and replace the circuit board to its original
position. Follow the instructions in reverse order to reassemble the
projector.
Note :
When rotating the projector back to its operational (in the lower
cabinet) position you should hear a spring loaded
'click'
as the
projector brackets engage with the slide rail in the correct position.
It will now be correctly positioned for the position locking screws to
be tightened at both sides of the projector.
Projector status LED
No light up : projector switched off
Green color : projector in Operational mode
Red color : projector is in Stand-by mode.
To start image projection, press the 'Stand by' button on the front local
control keypad or on the remote control. The projector mode status
LED lamp will be green.
When switching 'on' with the power switch, the projector starts in
the stand by mode. The projector mode status LED lamp is red.
Switching off
To switch off:
- press firstly the
STAND-BY
key and allow projector to cool down
until the fans stop blowing (or at least 15 min).
- then switch off the projector with the power switch on the front local
control panel.
Switching on
Use the power switch to switch on the projector, using the switch
on the front local control panel.
When '0' is depressed, the projector is switched off.
When '1' is depressed, the projector is switched on.
The projector is switched ON and OFF using the power (mains)
switch ON/OFF on the front local control panel keyboard
To gain access to the keyboard, refer to 'Front local Control panel
description and function' in chapter 1 'Location and function of
control'.
1 Pressed : ON
0 Pressed : OFF
Switching to stand-by
When the projector is running and you want to go to stand-by, press
the stand-by key.
Caution
: Before powering down the projector, switch the projector
to stand-by and let the projector lamp cool down until the fans stop
blowing (or for at least 15 minutes).
VOLTAGE
SELECTOR
PLUG-120V
a
FRONT CONTROL PANEL
+
+
+
+
+
0
9
7
8
6
5
4
3
2
1
+
BALANCE
+
+
VOLUME
+
BASS
+
CONTRAST
TREBLE
BRIGHTNESS
COLOR
TINT
SHARPNESS
ADJ
FREEZE
MUTE
PHASE
EXIT
PAUSE
TEXT
STBY
ENTER
B
B
B
B
B
B
B
B
B
B
ADDR
REMOTE CONTROL PANEL
HELP
Stand-By button
Power Switch
Projector Status LED
