![background image](http://html1.mh-extra.com/html/barco/r9002411/r9002411_owners-manual_4234514035.webp)
Service Mode
R5976101.02 BARCO CINE5 310102 ___________________________________________________________________________
7-3
PROJECTOR SET-UP
or
<EXIT> to return
then <ENTER>
Select with
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
POWERUP MODE : Standby
COMMON ADDRESS : 0
IDENTIFICATION
TOTAL RUN TIME
PROJECTOR SET-UP
or
<EXIT> to return
then <ENTER>
Select with
CHANGE PROJECTOR ADDRESS
POWERUP MODE : Standby
COMMON ADDRESS : 0
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
Total Run Time
Highlight
Total Run time
using the arrow keys and then press
ENTER
to
display the total time the projector has run since its first start up at the factory.
EXIT
returns to the Service Mode menu.
Note : All projectors leave the factory after a burn-in period of
approximately 100 hours.
Change Password
This item is password protected.
'
Highlight
CHANGE PASSWORD
using the arrow keys and then press
ENTER
. The current password is displayed. The new
password must consist of 4 digits, 0 to 9. Select the digit to be changed with the arrow keys and use the numeric keys to enter
the new digits.
Press
ENTER
to save the new password. Before saving, a confirmation screen will be displayed.
Press
EXIT
to return to the Projector Setup menu without saving the new password.
When the displayed password is correct, press
ENTER
to save. If not correct, press
EXIT
to cancel the saving.
PROJECTOR SET-UP
or
<EXIT> to return
then <ENTER>
Select with
POWERUP MODE : Standby
COMMON ADDRESS
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE PROJECTOR ADDRESS
PROJECTOR ADDRESS
Enter new projector address
0 0 0
and
<EXIT> to return
<ENTER> to confirm
Use
to select
and reprogram
with numeric keys
Highest address is 255
Change Projector Address
Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change the address, use the arrow keys to highlight
CHANGE PROJECTOR ADDRESS
and then press
ENTER
.
The Change Projector Address menu will be displayed and the actual current address will be displayed.
The first digit is highlighted. Select the individual digits using the arrow keys. Reprogram with the digit keys on the RCU.
Press
ENTER
to confirm. Press
EXIT
to return to the
PROJECTOR SETUP
menu.
CHANGE PROJECTOR
ADDRESS
Projector address will
be to ...
<ENTER> to confirm
<EXIT> to cancel
Enter
Password
****
PASSWORD
ENTER NEW PASSWORD
0 0 0 0
Use & to select,
and reprogram
with numeric keys
<ENTER>to confirm
<EXIT> to calcel
CHANGE PASSWORD
Password will be
reprogrammed as ...
<ENTER> to confirm
<EXIT> to cancel