Connections
R5976101.02 BARCO CINE5 310102 ___________________________________________________________________________
3-1
3
CONNECTIONS
Power (mains) cord connection
Use the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connector
on the rear of the projector.
Switching on/off
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed
: ON
Not pressed
: OFF
The projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode', depending on the software
setting in the service menu of the projector . This is done during installation by a qualified technician.
If you want to change this start up mode, call a qualified technician.
Stand by indication lamp
:
No light up
: Projector in operational mode
Red
: Projector is in stand by.
Leds on the rear plate of the projector
Signal input connection to the projector
- Composite Video
- S-Video
- RGBS or RGsB
- YsUV or YUVs [component input]
* Input signal Y/C (luma/chroma)
Connecting a Composite Video source
Composite video signals from a VCR, OFF air signal, decoder, etc.
120/230v
4A/2.5A
60/50 Hz
300 W
Stand By / Operational
Pause
Sync
Hold Down EHT
IR
TV Tuner
V C R
Audio
Amplifier
Composite
Video
Source No
Projector input
Press digit
1
Comp. Video
1
2
S-Video*
2
3
Tuner (When
option installed)
4
RGsB
4
5
RGBs
5
6
YsUV
6
7
YUVs
7
