![background image](http://html1.mh-extra.com/html/barco/r9002372/r9002372_owners-manual_4229355018.webp)
Controlling
4 - 2 _________________________________________________________________________ R5976381.01 BARCO CINE6 31012002
How to use the RCU
a.
Point the front of the RCU towards the reflective screen surface.
b.
Point the front of the RCU towards one of the IR sensors in the projector.
When using the RCU, make sure you are within the effective operating distance (10m or 30 ft. in a straight line). The RCU will
not operate properly if strong light strikes the sensor window or if there are obstacles between the RCU and the projector's IR
sensor.
c.
RCU used in a hardwired configuration. Plug one end of the remote cable in the connector at the end of the RCU and the
other end in the connector on the rear panel of the projector labelled 'REMOTE'.
Projector address
a.
Software setup of the projector address.
See
CHANGE PROJECTOR ADDRESS
in chapter
SERVICE MODE
.
Every projector requires an individual address between 0 and 255, which is set in the service mode. Only projectors with
addresses between 0 and 9 can be controlled with the RCU.
b.
How to control the projector.
The projector's address may be set to any value between 0 and 255. When the address is set, the projector can be controlled
with :
- the RCU for addresses between 0 and 9.
- a computer for addresses between 0 and 255.
Note : The projector will respond to a RCU set to an address of 0 regardless of what address is set
in the projector.
c.
Using the RCU.
Before using the RCU, it is necessary to enter the projector address into the RCU.
The projector with the corresponding address will respond to that RCU.
How to display the projector address.
Press the
ADDRESS
key (recessed key on the RCU) with a pencil.
The projector's address will be displayed in a 'Text box'.
45
o
45
o
45
o
45
o
CEILING
S
C
R
IR SENSOR
PROJECTOR
ADDRESS
001