![background image](http://html.mh-extra.com/html/barco/r767302k/r767302k_instructions-manual_474433035.webp)
24-1701050-00 /01
EC-200 to EC-210 Conversion Kit
35
11.
Attach the power cable to the left-side USB interface board and zip-tie it to the left-side breakout-board
standoff. (See #1 in Image 2-41.)
Tip:
Tie wrap the USB and other video cables to keep them from flopping around during transit.
12.
Zip-tie the 20
–
pin USB cable from USB910 to the AUDIO1 connector housing on the motherboard.
Image 2-42: USB from the right side of keyboard and trackball to USB910 zip-tied to AUDIO1 connector housing
1
USB cable zip-tied to AUDIO1 connector housing
Note:
The USB cable to the left-side display assembly may not be long enough to be zip-tied to the
AUDIO 1 connector housing.
Final chassis reassembly and power-on test
1.
Put the touchscreen assembly in place.
2.
Put the keyboard assembly in place, but do not secure it with the screws.
3.
Put the screen frame in place over the touchscreen assembly, but do not secure it with the screws.
4.
Perform a power-on test with the touchscreen and keyboard assemblies in place but not secured.
1.
Connect the unit to power. (Plug in the unit.)
2.
Make sure that the power supply switch is in the ON position.
The unit may power on, but if it does not, press the power button to turn on the power.
A Barco logo appears on each display as the unit boots.
3.
Check the power button on the rear of the unit.
The red ring around the power button should be illuminated.
4.
Verify that the touchscreens are functioning properly on both the left and right displays.
5.
Press the power button again.
The touchscreen displays the message,
“
Do you really want to power off the EC-200/EC-210?
”
6.
Select
“
Power off
”
on the touchscreen, and the unit should power down gracefully.
Once the unit has passed a power-on test, proceed with the final chassis reassembly.
5.
Secure the keyboard assembly in place with the four screws.
6.
Secure the screen frame in place over the touchscreen assembly with the six screws in front and three screws
in back.
7.
Affix the EC-210 product-label sticker over the EC-200 product label.
8.
Reattach the desklights.