Barco OV-508, Руководство по установке

Страница: 16 / 73

3. Mechanical setup
Barco - OV-508/OV-513/OV-515– R5990099 – installation manual – revision 01– November 2007 ________________________________
________________________________ ________________________________ ________________________________________________ ________________ ________________ ________________ 11
3 Mechanical setup
3.1 Tools needed for installation
•
1 drilling machine and a drill 4.9mm
•
1 set of screwdrivers (Torx)
•
1 right-angled torx key size 30
•
1 allen key size 5
•
1 allen key size 6
•
1 tape measure (10m)
•
1 tape measure (2m)
•
1 water level
To build up the mechanics of the OV series it is recommended to use a cordless screwdriver: the screws are self
tapping and the thread is cut while screwing them in.
If you have to unscrew, and screw in again, take care not to damage the thread! In case you have difficulties in
screwing in the screw, turn slightly into the opposite direction until the screw finds its thread. Only then proceed
with screwing in.
To connect profiles, KANYA connectors are used. The following explanation refers to all KANYA connecting
systems.
Insert the cross piece in the bore
hole of the profile Insert the anchor with the spring
into the centre hole of the profile Push the anchor head into the
longitudinal slot of the counter
profile. Rotate by 90°. Tighten the
allen screw.
With the OV-series, both, the anchor and the cross piece are already mounted into the respective profiles.