Barco NGS-D200, Руководство пользователя

Страница: 54 / 90

(Decoder)" on page 27
l
Horiz Position: Allows you to move the horizontal edge of your video in relation to the left corner of the display by
the specified number of pixels
l
Vert Position: Allows you to move the vertical edge of your video in relation to the top corner of the display by the
specified number of pixels
N
OTE: Horiz/Vert Position always apply to analog video. They will also apply to digital video when
DVI Mode is set to "LUT."
l
LUT Charge Pump Curr: (Analog Video Only) This is current that drives the generation of the pixel clock internal to
the decoder. When set to "Auto," it defaults to the optimal setting for the specific video input defined in the LUT
entry. It is not recommended to change this setting
l
DVI Mode: Allows you to control the way the horizontal and vertical delay of digital video is handled by the V2D:
o
Auto: Automatically detects the horizontal and vertical delay of digital video input, and the vertical horizontal
and position are appropriately adjusted
o
LUT: Uses the sum of the sync width and back porch defined in the in-use decoder video LUT to detect
horizontal and vertical delay of the video. The vertical and horizontal position are adjusted as per the
specified Horiz/Vert Position values
N
OTE: You should only need to change this setting if you are experiencing strange video shifting
(e.g. picture is to the right of center).
N
OTE: When you have finished making changes, click "Apply" at the bottom of the page. Click "Save Settings" to
permanently save your changes to the device.
11.2.6 List of Video LUTs
You can modify or configure a new LUT to support the source video (from DVI-I IN port) if it is not automatically detected.
1. Check to see if the resolution of the local source video is listed in the encoder LUT library
2. If it is not, click "Add" to add a new entry
3. Configure or modify the following:
K5903085
46
Chapter 11: Video