Barco NGS-D200, Руководство пользователя

Страница: 16 / 90

2.8 Device Defaults
All systems come with the following network configuration:
l
Multicast: Yes
l
Enabled: Yes
l
Primary: Yes
l
DHCP: Yes
l
MTU Size: 1500 bytes
N
OTE: For more information, see "Network Configuration" on page 25
2.9 Modes of Operation
The system has two unique operating modes:
l
Standalone Mode - Each device must be individually configured and managed
N
OTE: TransForm N users will operate the device in this mode.
l
Managed Mode (Barco Collaboration Suite) - Each device is centrally managed by the Barco Management Server
The unit must be set to operate in one of these modes. For more information, see "Standalone Mode" on page 58
2.9.1 Managed Mode
In Managed Mode, the device is used as part of networked, centrally managed, collaboration solution under the control of
the 4.x Barco Management Server. Bandwidth consumption can be dynamically provisioned in Managed mode.
If using Managed Mode, simply connect the unit to your network. If Auto Registration is enabled on the Management
Server, the NGS-D200 will be automatically registered and discovered. You can configure advanced settings centrally from
the Admin UI or use the Web UI, as described later in this document.
Please see the 4.x Admin UI Setup Guide for more.
l
The device is part of a centrally managed collaboration solution that enables flexible stream routing, synchronous
recording, advanced policy management and more
l
4.x Collaboration Suite users, select this mode.
2.9.2 Standalone Mode
The device is used for simple point-to-point connections enabling sharing of visually lossless video and graphics, audio,
and ultra-low latency keyboard/mouse control over IP. In Standalone Mode, the decoder is setup to connect to the encoder
without the help of a management system.
If using the NGS-D200 as a Transform-N DVI input node, then use the device in Standalone Mode.
Please see "Installation
and Configuration of TransForm N" for more on using the NGS-200 as part of the TransForm N environment
2.9.2.1 Standalone Mode Requirements
l
Both the encoders and decoders involved must:
o
Have the appropriate network settings configured
o
Have Standalone Mode enabled via the "Standalone Mode" page. For more information, see "Standalone
Mode" on page 58
K5903085
8
Chapter 2: Product Overview