Barco Medea series, Руководство по установке

Страница: 61 / 74

R5906141 /02 Medea series 61
5. Send power on command (to switch in ON mode).
7.4 Status overview
Description
Once the projector is started, press Status to get an overview of parameters such as :
• Chosen source
• Current resolution and refresh rate
• Device serial number and article number
• Current firmware version and model name
• Current illumination (in percentage)
• Lamp runtime in hours
• Chosen communication method and IP address (if connected)
• Warp status
• Environmental temperature
Image 7-3
7.5 Power off projector
How to Switch off the projector
1. Use the standby button , or the Power On button on the remote control, to switch off the projector.
The projector will switch to READY mode first in order to run through a cool down phase (see “ Power mode
transitions ” , page 59).
2. If ECO Standby mode is enabled in the service menu (refer to the section "GUI - system settings/Standby
ECO", in User Guide) the projector will automatically go to ECO standby mode after a time-out (default 15
minutes).
Some actions like apply a grey test pattern are done during the two minutes of the cool down phase
in order to minimize the potential effect of burn-in and increase the projector lifetime.
CAUTION: Never switch off the projector by means of unplugging mains cord or by cut down of
mains power.
Barco advises to keep the projector always powered and use the ECO mode for low power
consumption.
Getting Started