Barco Medea series, Руководство по установке

Страница: 59 / 74

R5906141 /02 Medea series 59
Mode
Description
ON (normal) Projector is booted up and the light source is on
READY Projector is booted up but the light source is off
ECO (Standby) Light source is switched off and projector electronics
are powered down
Energy consumption is significantly lowers in ECO (Standby) mode: only <0.5W if network is not
plugged in and 2W with network (Wake-on-LAN).
In ECO (Standby) mode, remote power up (Wake-on-LAN) and local power up (button) are
supported.
7.3 Power mode transitions
7.3.1 General
Transition Diagram
This diagram shows all modes available on the projector (unplug, ON, READY, ECO), and the actions
necessary to change mode.
2
ECO
READY
ON
1%
50%
50%
Image 7-2
-
Projector mains powered
-
Auto transition after x minutes if ECO mode enables
-
Press power On/Off button, remote On/Off button
7.3.2 Power on projector
If not already connected, connect the female side of the power cord with the power input socket of
the projector. For more details see section dedicated to the power cord installation.
Getting Started