Barco DP2K-12C, Руководство по обслуживанию

Страница: 24 / 359

3. Preventative maintenance actions
3.1 Monthly maintenance actions
MAINTENANCE TYPE A (perform every month)
The monthly maintenance actions, listed below, may be performed by a trained projectionist who is familiar
with potential hazards associated with the product.
No. Maintenance action Remarks
1 Clean all dust fi lters of the projector.
• dust fi lter at the front of the projector (electronics).
• dust fi lter at the top of the projector (cold mirror).
• dust fi lter at the bottom of the projector (heat exchanger).
Use a vacuum cleaner and blow
away the remaining dust away with
compressed air in another room. Take
care of orientation when reinstalling the
cleaned
fi lters.
Frequency at which fi lters should be
replaced is dependant on environmental
conditions and the way they can be
cleaned. Replace damaged
fi lters
immediately.
Front dust fi lter, "Removing the front
dust fi lter", page 333 , cold mirror fi lter,
"Clean the dust fi lter on the top side",
page 335 , .
2 Check the surface of the lens output side for dust. (it is not needed to remove
the lens from the projector) Clean the lens output side in case dust
is clearly visible upon the surface. See
"Cleaning the lens", page 185. Note
that if the lens was removed from the
projector, a home and return must
be executed. See user guide of the
Communicator software.
3
Check the porthole (both sides) for dust. Clean the porthole in case dust is clearly
visible upon the surface. Use an optical
cloth.
20 R5905043 DP2K-12C/11CX 19/02/2018