Barco DATA 708HS R9002230, Руководство пользователя

Страница: 42 / 59

7-4
Service Mode
5975589 BARCODATA 708 HS 080998
Change Projector Address
Every projector requires an individual address between 0 and 255.
This address can be software installed.
To change that address, push the control disk up or down to highlight
'Change Projector Address' and press ENTER . The Change Projector
Address menu will be displayed and the actual address will be filled
in.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
ENTER displays the 'Change Projector Address' menu.
EXIT returns to the Service mode main menu.
The first digit is highlighted. Select the individual digits by pushing the
control disk to the right or to the left. Reprogram with the digit keys
on the RCU.
Press ENTER to confirm.
Press EXIT to return to the projector set up menu.
<ENTER> to confirm
<EXIT> to return.
PROJECTOR ADDRESS
Enter new projector
address :
0 0 0
Use ç and è to select,
and reprogram
with numeric keys.
Highest address is 255
Change Baud Rate
The communication speed between projector and computer has 8
possible speeds. The baud rate speed can be software set up.
Highlight 'Change Baudrate' by pushing the control disk up or down
and press ENTER to display the Baud rate menu.
The following baud rates are available :
- 9600
- 4800
- 2400
- 1200
- 600
- 300
- 150
- 110
The actual baud rate will be highlighted. To change the baud rate,
push the control disk up or down or to the left or to the right to select
the desired baud rate and press ENTER to accept this baud rate.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
<ENTER> to accept
<EXIT> to return.
BAUDRATE
Select new
baudrate :
9600 4800
2400 1200
600 300
150 110
Select with arrow
keys ;
ENTER to accept the selected baud rate.
EXIT to return without changing the baud rate.
Power Up Mode
When pressing the power switch, the projector can start up in
'operating mode' or in 'standby mode'.
Operating mode : the projector start up and displays image .
Standby mode : the projector start up in standby and waits until the
standby button or a digit key is pressed.
To change the Power up mode, select Power Up mode by pushing
the control disk up or down and press ENTER to toggle between
'Operating' and 'Standby'.
Select with ê or é
then <ENTER>
<EXIT> to return.
PROJECTOR SETUP
IDENTIFICATION
TOTAL RUN TIME
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJECTOR ADDRESS
CHANGE BAUDRATE
POWER UP MODE : operating
BARCO LOGO
ENTER to toggle between operating and standby.
EXIT to return to the Service menu.