Barco Coronic Uniti, Руководство пользователя

Страница: 29 / 74

K5902079-07 Coronis Uniti 29
illuminated and are now available for further actions. However, if no further actions are taken within the
following 5 seconds, the keys will dim again.
The I-Luminate/Left key is always lit and available for activation of the I-Luminate feature. Please
refer to
“ I-Luminate ” , page 31 for more information.
The key auto-dim function can be disabled in the OSD menus. Please refer to “ Key indicator lights ” ,
page 35 for detailed instructions on how to do this.
4.3 Standby switching
The connected power supply also provides a switch that can be used to turn the power completely
off. To use the display, please make sure to switch on this power supply. This can be done by
pushing the on/off switch on the power supply into the
“│” position.
To switch your display on using the keys:
Switching on the display while it is in standby mode can be done by:
1. Push the standby key once.
As a result, the display will switch on and the power status indicator light is white .
During start-up phase, the orange indicator light and the white indicator light are lit, until the unit is
fully started.
To switch your display to Stand-by using the keys:
Switching off the display can be done by:
1. Push the standby key shortly for three times. After the second push, the OSD message “ Power off ” appears
on the display, this means the display will go in standby mode.
As a result, the display will switch to stand-by mode and the power status indicator light is orange .
In case of a power outage recovery, your display will always start-up in the power mode it was in
before the power interruption (i.e. stand-by or on). This protects your display against inadvertent
image retention problems.
4.4 Bringing up the OSD menus
How to bring up the OSD menus
The OSD menu allows you to configure different settings to make your Coronis Uniti fit your needs within your
working environment. Also, you can retrieve general information about your display and its current
configuration settings through the OSD menu.
Bringing up the OSD menus can be done by:
1. If not already done so, switch on the display as previously described.
2. Illuminate the keys as previously described.
3. While the keys are illuminated, touch the menu key.
As a result, the OSD main menu comes up. However, if no further actions are taken within the following 90
seconds, the OSD will disappear again.
Daily operation