Installing Barbecue Components
9.
This Gas Grill must be connected to an appropriate
REGULATED gas supply - refer to Safety Information.
10.
Install Heat Shields
between burners as
shown in
Figures
6a & 6b
. There are
2 shields required
for the 3 burner
barbecue, 3 shields
for the 4 burner
model and 4 shields
for the 5 burner
model.
We recommend that you fill the drip tray with
Ultrasorb
approximately 1/4" deep. This will help absorb any grease or
residues from the barbecuing process. Change the Ultrasorb
on a regular basis. A fire may occur if the grease level rises
to the top of the
Ultrasorb
. Sand can be used as an alterna-
tive to
Ultrasorb
.
11.
Remove the Stainless Steel burners from packaging and
place into Barbecue. The open end of the burner has to
be installed over brass stem of valve and then the rear
of the burner is lowered down onto the back bracket
locating the cast peg into the appropriate hole (
Figure
7
).
Note: Air Adjustment
- The bolt on the side of each burner
should be screwed half way in and secured with the locking
nut prior to installation.
Figure 6a
Lip rests on
rear ledge
between burner
mounting holes.
Burner
Heat Shield
Fit into Brass
Stem on Valve
Cast Peg on burner
rests in hole
Figure 7
12.
Remove the Stainless Flame Tamers from carton and
install them into the barbecue above the Burners
(
Figure 8
). Place the ceramic briquettes in position as
shown in (
Figure 9
). The Flame Tamers must sit level if
correctly installed.
Note:
If installing the alternate Lava Rock Grate (Turbo
Classic models only), layer the lava rocks evenly - DO NOT
PILE (
Figure 10
).
13.
Place the Stainless Steel Cooking Grids in place.
Tip: - A light coating of vegetable oil will prevent food from
sticking to the grills.
Figure 8
position Flame Tamers
against vertical wall of BBQ
rest on rear tab
Figure 9
Stainless Flame
Tamers with
Ceramic Rocks
Figure 10
-
6
-
Place Burner Heat
Shield as shown
Figure 6b
Содержание Turbo CG3TCBN
Страница 2: ......
