-
5
-
Turbo Elite: Stainless Steel Hood Installation
4.
Remove the Hood Assembly from the carton carefully.
The Top Hinges have been aligned and fastened to the
hood section prior to delivery.
5.
Place barbecue on a stable flat surface and fit the
Bottom Hinges with Warming Rack Brackets on the inside
of the barbecue frame using the bolts, lock washers, and
nuts provided (
Figure 4
).
DO NOT TIGHTEN NUTS AT THIS STAGE. FINGER
TIGHT IS SUFFICIENT
.
IMPORTANT: IF BARBECUE IS TO BE INSTALLED ON A
CART, ASSEMBLE TO CART PRIOR TO ASSEMBLING
HOOD TO BBQ FRAME TO MAKE CART ASSEMBLY
EASIER
.
6.
Place the hood section onto the barbecue in the closed
position. Align holes on Top and Bottom Hinges and
insert Hinge Pivot Pins into position (you may have to
move the bottom halves of the hinge assemblies to
achieve alignment). Now fit the retaining clips into the
hinge pivot pins (
Figure 4
).
7.
Roll the assembled barbecue and hood onto its back
edge while holding the hood closed with one hand,
tighten the four (4) nuts, securing the hinge and warming
rack bracket with the other hand (
Figure 5
).
8.
If your barbecue is equipped with a rear rotisserie burner,
the bottom hinges are pre-attached to the rear rotisserie
burner mount and there is no need to attach them.
Warming Rack
Bracket
Figure 4
Hinge
Bottom
Hinge
Pivot Pin
Dome Nut
Hinge Top
Lock
Washer
Retaining
Clip
Hold lid in closed position while tightening nuts.
Figure 5
Содержание Turbo CG3TCBN
Страница 2: ......
