9
BARACUDA | TITAN 2 ECO 3
| Installation & Operating Instructions
9
BARACUDA |
TITAN 2 ECO 3
|
Installation & Operating Instructions
•
The pump is equipped with a thermal overload protection.
If overload occurs during operation, the built in overload
protection automatically deactivates the pump. The pump will
switch on automatically after a cooling period of approximately
20 (twenty) minutes. Ensure the cause of the overload is identified
and addressed . If the pump remains on a continuous locked
situation causing thermal overload, the motor may eventually
damage and burn out.
•
Note that certain parts are subject to normal wear and tear, even
when used properly and must be replaced in due time, depending
on type and duration of use.
These include but are not limited to:
• Impeller
• Shaft Seal
• Motor Bearings
• Pump lid and O-ring
• Pump basket
• Diffuser
•
All work listed in this manual must be performed regularly.
If this maintenance work cannot be performed by the end-user,
an authorised person must be commissioned to perform this work.
If these operations are neglected, faults may arise which are the
responsibility of the user.
These include:
• Damage to the motor, due to untimely or inadequate
maintenance or cleaning of the cooling fan cover
• Corrosive or other damage caused by incorrect storage
of chemicals in pump enclosure
• Damage due to the use of spare parts which are not
original Baracuda parts
• Damage due to maintenance and repair work not
carried out by qualified technicians
•
To avoid personal injury do not have the pool pump running whilst
there are people in the pool/spa.