Banner SX5-B, Инструкция по эксплуатации

Страница: 21 / 135

Figure 12. Monitored space as shown by the configuration software
2.10 Security Protocol
Certain procedures for installing, maintaining, and operating the SX must be performed by either Designated Persons or
Qualified Persons.
A
Designated Person is identified and designated in writing, by the employer, as being appropriately trained and qualified to
perform system resets and the specified checkout procedures on the SX. The Designated Person is empowered to:
• Perform manual resets and hold possession of the reset key (see )
• Perform the Daily Checkout Procedure
A Qualified Person , by possession of a recognized degree or certificate of professional training, or by extensive knowledge,
training, and experience, has successfully demonstrated the ability to solve problems relating to the installation of the SX
System and its integration with the guarded machine. In addition to everything for which the Designated Person is
empowered, the Qualified Person is empowered to:
• Install the SX System
• Perform all checkout procedures
• Make changes to the internal configuration settings
• Reset the System following a Lockout condition
2.11 General Safety Information
• The machine stopping system must be electrically controlled.
• This control system must be capable of stopping the dangerous movement of the machine within the total machine
stopping time (Ts) and during all the machine cycle phases.
• The device mounting and connections, must be carried out by qualified personnel only, according to the instructions
included in the mechanical installation and electrical connection sections of this manual and applicable standards.
• The safety laser scanner must be securely placed in a particular position so that access to the dangerous zone is not
possible without passing through the Safety Zone of the scanner.
• The personnel operating in the dangerous area must be well training and must have adequate knowledge of all the
operating procedures of the machine and safety laser scanner.
• In cases of Manual Restart, the reset button must be located outside the safety area, see the reset switch location
section of this manual.
SX Safety Laser Scanner
www.bannerengineering.com - Tel: + 1 888 373 6767 21