Banner Q3XTBLD150-Q8, Инструкция по эксплуатации

Страница: 12 / 31

3.2 Manual Adjustments
Manually increase or decrease gain using or .
1. From Run mode, press either or one time. The current signal strength value flashes slowly.
2. Press to decrease the sensor's gain or to increase the sensor's gain, or press and hold or to rapidly decrease or
increase gain. After 1 second, the normalized signal strength flashes rapidly, the new setting is accepted, and the sensor returns
to Run mode.
3.3 Remote Input
Use the input wire to program the sensor remotely. To program the sensor using the input wire, remote input must be enabled ( =
, Input Wire Function on page 10). The remote input provides limited programming options (see Figure 7 on page 12). Pulse
the remote input according to the diagram and the instructions provided in this manual.
The length of the individual programming pulses is equal to the value T: 0.04 seconds ≤ T ≤ 0.8 seconds.
1x
2x
Teach Selection
Starts selected Teach (same function as pressing Teach Button for > 2 sec)
1x
Second pulse completes Teach (Two-point and Dynamic Teach only)
0.04 seconds < T < 0.8 seconds
Timing between Pulse groups > 1 second
Pulse Timing (T)
(gray wire is input wire)
2x
1x
Two-point static background suppression
Dynamic background suppression
4x
3x
One-point window set
One-point light set
4x
2x
1x
Button Unlock
Button Lock
Button Lock
8x Reset to Factory Defaults (maintains remote input = SET)
Remote
Input
5x
One-point dark set
REMOTE SETUP
REMOTE TEACH
= Set
3x
Operator Lock
Figure 7. Remote Input Map
3.3.1 Select the TEACH mode using the Remote Input
1. Access the TEACH selection.
Action Result
Double-pulse the remote input.
T T
T
displays.
2. Select the desired TEACH mode.
Q3X Laser Contrast Sensor
12 www.bannerengineering.com - Tel: 763.544.3164