Table 2:
Cut-off
output
settings
and
operation
Output State Based on
menu and LO/DO
Selections
Target in
Cut-Off
No Light Received (Loss of Signal)
LO/DO
LO/DO
OFF
LO/DO
ON
LO/DO
Note: The output may
transition
ON to OFF or OFF to ON when the target enters the
diffuse
sensing range. Consider an ON-Delay
or the laser inhibit input if necessary.
3.1.9 Display View
Use this menu to select the display view. The default is right-reading.
•
—Right-reading
•
—Inverted
•
—Right-reading and the display enters sleep mode
after
60 seconds
•
—Inverted and the display enters sleep mode
after
60 seconds
When the sensor is in sleep mode, the display wakes with the
first
button
press.
3.1.10 Exit the Top Menu
Navigate to
and press TEACH and MODE together to exit the top menu and return to Run mode.
Setup mode can also be exited by pressing and holding
and
simultaneously for longer than 2 seconds from anywhere in the top
menu.
3.1.11 Reset to Factory Defaults
Use this menu to restore the sensor to the factory default
settings.
Select
to return to the sensor menu without restoring the
defaults. Select
to restore the sensor to the factory default
settings
and return to Run mode.
Factory Default
Settings
Setting
Factory Default
Display view (
)
—Right-reading, no sleep mode
Input wire
function
(
)
—Ignore all pulses
Offset
Percent (
)
—20%, Window and Light Set
—50%, Dark Set
Output
operation
(
)
—Light operate
Output
timing
delays (
)
—No delay
Response speed (
)
—1 ms
Sensitivity
(
)
—Standard
sensitivity
TEACH process
selection
(
)
—Two-point
static
TEACH
Q3X Laser Contrast Sensor
www.bannerengineering.com - Tel: 763.544.3164
11
