Banner DXMR110-8K, Инструкция по эксплуатации

Страница: 13 / 38

© Banner Engineering Corp. www.bannerengineering.com 10
Q
UICK
S
TART
G
UIDE
3.2.2.1. Modify Multiple Registers
Modify a range of registers from the Local Registers > Local Registers in Use > Modify Multiple Registers screen.
C
ONTEXT
:
Select which parameter fields to modify. Most parameters have three selections.
• Unchanged—no changes
• Default—change to default settings
• Set—modify the parameter. Other selections will appear based on the parameter.
Figure 5: Modify Multiple Registers screen
1. Enter the
Starting register
and
Ending register
.
2. Select the value to change using the drop-down list next to each value.
3. Enter the new value in the field provided.
4. To push register values to the web server, set
Cloud Permissions
to read.
If the
Cloud Permissions
are set to Read, the web server only views data from the device and cannot write data to the device. If the
permissions are set to Write, the web server only writes to the device and cannot read the data. If the permissions are set to
Read/Write, the web server can read the data from the device and write to the device from the web.
5. Click
Modify Registers
to save and apply the changes.
3.2.2.2. Set the IP Address
Follow these instructions to change the DXMR110-8K's IP address.
C
ONTEXT
:
By default, the DXMR110-8K is set to a static IP address of 192.168.0.1. The IP address can be changed by using the DXM Configuration Soft -
ware and updating the XML.
1. Launch the DXM Configuration Software.
2. Go to the Settings > Ethernet screen.
3. In the IP Address section, select Static IP or DHCP from the drop-down list.
• If Static IP is selected, enter the IP address , Subnet , and Gateway address as desired.
• If DHCP is selected, the IP address , Subnet , and Gateway address are grayed out and not configurable.
Changing the IP Address to DHCP can make it so the DXM cannot be reached. Before changing this to DHCP , you MUST have
a server that is going to assign an IP Address to the DXMR110-8K.
4. Save your changes to the configuration file ( File > Save ).
5. Upload the configuration file to your controller ( DXM > Send Configuration to DXM ).