Banner DXM1200-X2, Инструкция по эксплуатации

Страница: 39 / 83

February 02, 2024
DXM1200-X2 Controller Instruction Manual
© Banner Engineering Corp. All rights reserved.
39
•
•
•
Installing the cellular modem
1
2
3
Install the Cellular Modem (DXM1200 Models)
Follow these steps to install the cellular modem and antenna cable.
IMPORTANT:
Electrostatic discharge (ESD) sensitive device
ESD can damage the device. Damage from inappropriate handling is not covered by warranty.
Use proper handling procedures to prevent ESD damage. Proper handling procedures include
leaving devices in their anti-static packaging until ready for use; wearing anti-static wrist straps;
and assembling units on a grounded, static-dissipative surface.
SIM cards come in a credit card sized carrier. Carefully snap it out of the carrier. 1.
Make note of the IMEI number of the cellular modem and the ICCID number of the SIM card.
The numbers can be found on the cellular modem and the SIM card or SIM card carrier. You will need the SIM
number to associate a wireless plan to this SIM card.
2.
Insert the SIM card into the socket on the underside of the cellular modem while ensuring the conductive pads on the
SIM card are interfacing with the terminals of the modem.
There is a matching notch in the socket and SIM card that will only allow the SIM to be inserted with one orientation.
Do not force the SIM card into the socket.
3.
◦
◦
Orient the cellular modem according to the pin layout.
DXM100, 150, and 1000
Modem
*SIM card is located on the underside of installed modem
Antenna Cable
DXM700
Modem
*SIM card is located on the underside of installed modem
Antenna Cable
For the DXM100, DXM150, and DXM1000 models—Install the cellular modem board onto the processor
board as shown. Use the diagram to verify the orientation is correct.
For the DXM700 models—Install the cellular modem board onto the base board as shown. Use the diagram to
verify the orientation is correct.
4.
Verify the pins are properly aligned. a.
Verify the hole in the cell modem aligns with the hole on the DXM board. b.
Firmly press the modem into the 24-pin socket. c.
Attach the antenna cable between the cellular modem board to the base board as shown. 5.
Install the external cellular antenna on the DXM's SMA connector located next to the antenna cable. 6.